ClearPath IX Systems Installation and Configuration Guide

Installing the Basic OS 2200 IOE
dn devname
Caution
Once you continue with the boot, you cannot bring down any fixed mass storage
devices without a reboot. Be sure the correct disks are up before proceeding.
16. Enter the following to continue with the boot:
n go
You are prompted to enter the security officer user-id.
n ENTER 12-CHARACTER SECURITY OFFICER ID
17. Enter security as the default security officer user-id as follows:
n security
You are prompted to enter the master account number.
n ENTER MASTER ACCOUNT
18. Enter 0 (zero) as the master account number.
n 0
Several messages are displayed. Initial boot is finished when the following message
appears:
SYS FIN
The run MSCPRT will start after SYS FIN. This is a background service run and can be
left active.
Continue installation with the procedures in 13.3.
13.3. Installing Products from Tape HMP-FLD
Once OS 2200 is initialized, take the following steps to install the first-load tape labeled
HMP-FLD:
1. Enter the following command to start the installation runstream:
ST INSTALLFLD
You are prompted to enter the reel number for the reel or reels you are loading:
INSFLD START
n INSTALLFLD: Enter reel number
13–6 Version 009B (Web Only) 7850 5104–009