ClearPath IX Systems Installation and Configuration Guide

Installing the Basic OS 2200 IOE
5. Set jump keys for library load (jump key 4) and initialization (jump key 13) as follows:
sj 4,13
Whenever jump key 13 is set, a prompt appears with a field for specifying the
reinitialize option.
6. In the field that appears, set the reinitialize option by typing the following entry and
pressing Enter twice.
destroyfiles
7. Load the tape HMP-BOOT in the tape drive specified in step 2.
8. Start the partition by entering the following SCF command:
sp
The Start Partition command initializes the partition and performs an initial program
load of the partition.
9. Press the F4 key to change to the System Operations session. The following message
is displayed:
n MODIFY CONFIG, THEN ANSWER: DONE
10. Before continuing the boot process, determine the current state of peripheral devices
by entering appropriate facility status (fs) keyins. For example, check the status of all
mass storage devices with the following keyin:
fs,ms
You can use this keyin to display only disks that are up:
fs,adisk
11. Use the UP or DN keyin to set devices to the state you want for the partition.
12. When done, end modification of the configuration by entering the following:
n done
where n is the number of the MODIFY CONFIG message requiring a response.
In response to that message, the following message appears:
n ARE YOU SURE YOU WANT JK 13 SET? ANSWER Y OR N
13. Enter Y to confirm that you want to perform an initial boot:
n Y
A messages appears indicating the number of fixed mass storage disks that are up:
n FIXED MS DEVICES= m - CONTINUE? YN
14. Answer yes (Y).
n Y
A message solicits down keyins. You must bring down disks that should not be up.
n ENTER LOCAL DOWN PACK KEYINS - ANS GO
15. Enter keyins to down devices as needed. (If no device must be downed, continue with
the next step.) For example,
7850 5104–009 Version 009B (Web Only) 13–5