ClearPath IX Systems Installation and Configuration Guide

Configuring Intel Nodes for Monitoring by SPO
12.8. Installing the SPO Windows Agent
To fully enable control of each Windows 2000 and Windows NT node by SPO Basic
Edition, you must install the SPO Windows Agent that you previously transferred to each
node (12.4).
Note: In this procedure, it is assumed that you have already logged on to SPO Basic
Edition as the operator (12.7).
The procedure is as follows:
1. In the TopCluster window of SPO Basic Edition, click the desired Windows 2000 or
Windows NT node icon.
The Windows desktop for the selected node takes over the SPO workstation screen.
2. Switch to viewer mode, then click Start, Programs, Command Prompt.
A command prompt window opens.
3. Type the following command, then press Enter to change to the installation directory
(if you are not already in that directory):
cd \InetPub\ftproot\temp
4. Enter the following command to start the installation program:
spinst
When the command prompt returns, the installation is complete.
5. Type exit and press Enter.
6. Press Ctrl-Shift-Esc to exit from the Windows 2000 or Windows NT node and return to
SPO Basic Edition control.
7850 5104–009 Version 009B (Web Only) 12–11