ClearPath IX Systems Installation and Configuration Guide

Configuring Intel Nodes for Monitoring by SPO
Continue by configuring the Windows server nodes for ControlIT (12.5).
12.5. Configuring Windows Intel Nodes for ControlIT
Perform this procedure for each Windows 2000 and Windows NT Intel node, so that
ControlIT can monitor and control the nodes. In this procedure, it is assumed that you are
still logged on to the Single Point Configuration routine.
1. In the TopCluster window displayed by the configuration routine, click Edit, then
Windows Systems.
A table listing each Windows 2000 and Windows NT server node appears.
2. For each of the Windows NT server nodes, do the following:
a. Click Program. A dialogue window appears.
b. Select Remotely Possible/32. (This also works for ControlIT.)
c. Click OK.
Note: Do not perform this procedure (step 2) for the SPO workstation cp_ws (PC
running Windows NT Workstation).
3. Close the Edit Windows Systems window.
4. On the configuration routine's main menu bar, click File, then select Save from the
drop-down menu that appears.
A window asks whether you want to perform configuration verification.
5. Click Yes.
When configuration verification is done, a window asks whether you would like to
verify network connectivity.
6. Click Yes.
A message indicates that network connectivity has been verified.
7. Click Continue.
After you have performed this procedure for each configuration, continue with the
procedure in 12.6.
7850 5104–009 Version 009B (Web Only) 12–7