ClearPath IX Systems Installation and Configuration Guide

Configuring Intel Nodes for Monitoring by SPO
2. In the Maintain UNIX Agents window, select the default URM policy and security
scheme for each node (system) as follows:
• For the SPO server (SPO_Server), take the following steps:
− Click the hyphen (-) in the URM Policy column.
A dialogue window appears.
− In the dialogue window, click default, then click OK.
The word default appears in the URM Policy column for SPO_server.
• For each UnixWare node (CP_UNIXx), take the following steps (skip these steps if
you have no UnixWare node):
− Click the hyphen (-) in the URM Policy column.
A dialogue window appears.
− In the dialogue window, click default, then click OK.
The word default appears in the URM Policy column for CP_UNIXx.
− Click Access Allowed in the Security Scheme column for CP_UNIXx.
A dialogue window appears.
− In the dialogue window, click Always Ask, then click OK.
Repeat these steps for each UnixWare node.
Figure 12–1 shows how the window should look if these steps are performed for both
the SPO server and a single UnixWare node.
3. In the Maintain UNIX Agents window, select Execute, then Install.
A dialogue window appears identifying systems on which the agents can be installed.
4. Click SPO_Server, then click each of the CP_UNIXx systems.
They appear in the lower half of the window.
5. Click OK. Messages for the SPO server and UnixWare nodes appear as follows (the
order may vary):
• For the SPO server, a message indicates that the URM agent was installed
successfully. Click Continue to proceed.
• For each UnixWare node, a dialogue box asks for the root password for that
system. Respond as follows:
a. Enter the root password. (Your typing is not displayed.)
b. Press Enter.
A message indicates that the URM agent was installed successfully.
c. Click Continue to proceed.
6. Verify that the URM agent on the SPO server is running as follows:
a. At the SPO workstation, open a new X terminal window session by positioning the
cursor on the screen background, clicking the right mouse button, selecting New
Window, and then releasing the mouse button.
7850 5104–009 Version 009B (Web Only) 12–5