ClearPath IX Systems Installation and Configuration Guide

Installing and Configuring SPO Workstation Software
10. If necessary, change the drive and directory, and click the check box to set it. When
done, click Install to begin the installation. Files will be copied to disk.
A Winsock RSHD/NT warning window is displayed next.
11. Click Yes on the warning window.
After a brief wait during which files are copied, the following prompt appears:
Do you want to start the Winsock RSHD/NT Service automatically when
Windows NT starts?
12. Click Yes.
The Winsock RSHD/NT install completes, and the service is installed and automatically
appears in the Windows list of services following reboot.
13. Answer Yes or No to the message about reading the manual.
14. Close the Add/Remove Programs window (click X in the upper right-hand corner).
15. Close the Control Panel window.
16. Remove the diskette from the drive.
17. Reboot the Windows 2000 workstation.
Continue by changing the default Windows password (11.14.3); then proceed to Section 12.
11.14. Installing SPO Product Information on the
Workstation
Documentation for the SPO product is provided on a CD-ROM labeled “SPO HMP Console
for UnixWare Product Information CD-ROM.” Follow these steps to install the
documentation on the SPO workstation:
1. Insert the CD-ROM labeled “Single Point Operations Product Information” into the
SPO workstation CD-ROM drive.
2. If the CD-ROM Setup window launches automatically, click Exit to close it.
3. Open the Windows Explorer as follows:
• For Windows NT 4.0 click Start > Programs > Windows NT Explorer.
• For Windows 2000 click Start > Programs > Accessories > Windows Explorer.
4. Create a spo-pi folder on the C drive as follows:
a. Click once on the C drive to highlight it.
b. On the main menu bar, click File, then click New > Folder.
c. In the highlighted New Folder box that appears in the right-hand pane, type spo-pi
to name the folder.
d. Press Enter.
7850 5104–009 Version 009B (Web Only) 11–37