ClearPath IX Systems Installation and Configuration Guide

Installing and Configuring SPO Workstation Software
b. Click Shut Down.
c. Click to get the drop-down menu, then click Restart.
d. Click OK.
16. Log on as the administrator (11.14.1) using the logon dialogue box that appears.
17. If an XVision screen appears, close it by clicking X in the upper right-hand corner; then
click OK to the message saying your XVision session will end.
18. Remove the CD-ROM from the drive.
Continue by installing Winsock RSHD/NT.
11.13.3. Installing Winsock RSHD/NT on the Windows 2000
Workstation
Winsock Remote Shell Daemon (RSHD/NT) is a Windows service that supports ControlIT
by providing Remote Copy (RCP) server capabilities. Once installed, Winsock RSHD/NT
runs as a service that automatically starts whenever the SPO workstation is booted. No
further user interaction is required.
Install Winsock RSHD/NT as follows:
1. If you are not currently logged on, power on or restart the SPO workstation and log on
(11.14.1).
2. Insert the Remote Shell Daemon diskette (labeled “Winsock RSHD/NT”) into the
floppy drive.
3. Click Start, Settings, then Control Panel.
4. Double-click the Add/Remove Programs icon.
An Add/Remove Programs window appears.
5. Click the Add New Programs icon.
A dialogue box appears.
6. Click the CD or Floppy box.
You are prompted to insert the product diskette or CD-ROM. The diskette labeled
“Winsock RSHD/NT” should already be in the floppy drive. If it is not, insert it now.
7. Click Next.
A Run Installation Program window appears.
8. Click Finish. Windows 2000 momentarily displays the Add/Remove window. Then a
Winsock RSHD/NT installation window appears.
9. Verify that the information shown in the window is correct:
• The destination drive and directory should be C:\WRSHDNT.
• The box labeled Install as a Windows NT Services should be checked.
11–36 Version 009B (Web Only) 7850 5104–009