ClearPath IX Systems Installation and Configuration Guide

Installing and Configuring SPO Workstation Software
c. Make sure the X Display number is 0 (default).
d. Verify in the Advanced, Extensions area that only SHAPE is selected. Click the
scroll bar to scroll down and uncheck any items that are checked, other than
SHAPE.
e. Click the Security tab.
f. Click the XDMCP check box to select it, then click Direct.
g. Type the IP address of the SPO server in the Host entry box. No other boxes on
this tab should be checked.
h. Click the Diagnostics tab.
i. Clear the check box for Helpful Interactive Support.
3. Click OK to complete the XVision configuration.
A window asks whether you wish to restart the XVision server.
4. Click Yes.
If the Intel node is running UnixWare, proceed to Section 12.
If the Intel node of the ClearPath system is running Windows 2000, minimize the XVision
window now and proceed by installing ControlIT and Winsock RSHD/NT, as described in
11.12.2 and 11.12.3.
11.13.2. Installing ControlIT on the Windows 2000 Workstation
The procedure for installing ControlIT is as follows:
1. If you are not currently logged on, power on or restart the SPO workstation and log on
as the administrator (11.14.1).
2. Insert the ControlIT CD-ROM (labeled “ControlIT Advanced Edition”) into the drive
unit.
When the CD-ROM has been inserted, the installation program starts automatically.
The Management Solutions window appears.
3. Under Install Your Product, click ControlIT.
After an initial ControlIT window, the License Agreement window appears.
4. Click I Agree.
You are asked to select the type of ControlIT environment to install. Select Install
Non-Managed Viewer and Host Components.
5. Click Next.
The Installation Wizard on the ControlIT Setup screen appears. Make sure Install
Agent Viewer is checked and Install Agent Host is not checked. Under Setup Options,
select Advanced.
6. Click Next.
A screen for installing Unicenter TNG Framework appears.
11–34 Version 009B (Web Only) 7850 5104–009