ClearPath IX Systems Installation and Configuration Guide

Installing and Configuring SPO Workstation Software
To make the SPO Basic Edition fonts available to XVision, you must copy the fonts from
the SPO server to the SPO workstation and then install them. The procedures for these
tasks are given next.
This procedure describes how to copy the SPO Basic Edition fonts from the SPO server to
the SPO workstation:
1. If you are not currently logged on, power on or restart the SPO workstation and log on
(11.14.1).
2. Click Start, Programs, Accessories, then Command Prompt.
A command prompt window opens.
3. At the command prompt, type the following command, then press Enter to change to
the directory containing XVision fonts.
cd \progra~1\vision\fonts
4. Create a subdirectory under that directory, and then change to it, by entering the
following commands:
mkdir spofonts
cd spofonts
5. Initiate an FTP session by entering the following command:
ftp sposerver-ip
where sposerver-ip is the Ethernet IP address of the SPO server (see Table 2–2).
An FTP logon prompt appears.
6. Still on the workstation, log on to the server as follows:
a. Type spadmin (the SPO administrator user-id).
b. Press Enter to advance to the password field.
c. Type unisys1234 (the default installation password).
d. Press Enter again.
7. Enter the commands below to accomplish the following tasks:
• Set the transfer mode to binary.
• Turn off interactive prompting.
• Change to the XVision fonts directory on the SPO server.
• Transfer the font files to the PC.
These are the commands:
binary
prompt
mget /opt/SPO/XP/xvfonts/*.*
8. Enter the following commands to exit FTP and the command prompt window:
quit
exit
11–32 Version 009B (Web Only) 7850 5104–009