ClearPath IX Systems Installation and Configuration Guide

Installing and Configuring SPO Workstation Software
17. Select the Home Directory tab and check the Write box in the FTP Site Directory
section.
18. Click OK.
19. Close the Internet Information Services window (click X in the upper right-hand
corner of the window).
20. Close the Administrative Tools window.
Continue by installing the SPO display software, as described next.
11.13. Installing SPO Display Software on the
Windows 2000 Workstation
SPO display software includes SCO XVision, ControlIT (a product of Computer
Associates), and Winsock RSHD/NT. This section gives the following procedures for
installing these products, in the order shown:
1. Install and configure XVision.
2. Install ControlIT.
3. Install Winsock RSHD/NT.
The installation procedures are described next.
11.13.1. Installing and Configuring XVision on the Windows 2000
Workstation
XVision is an X terminal emulator that runs on the SPO workstation. XVision allows the
SPO workstation to display SPO Basic Edition screens for monitoring and controlling
ClearPath IX server components.
Install and configure XVision on the SPO workstation as follows:
1. If you are not currently logged on, power on or restart the SPO workstation and log on
(11.14.1).
2. Insert the CD-ROM labeled “SCO Vision 2K” into the drive unit.
A SCO Vision 2K screen appears.
3. Click Install.
The SCO Vision 2K Setup Wizard appears.
4. Click OK.
A product-selection menu appears.
5. Select SCO XVision Eclipse 7.3.
6. Click Next.
A setup options menu appears.
11–30 Version 009B (Web Only) 7850 5104–009