ClearPath IX Systems Installation and Configuration Guide

Installing and Configuring SPO Workstation Software
11.9. Setting Up the Windows 2000 Workstation If
Windows Is Preloaded
The next subsections tell how to prepare the SPO workstation for use if Windows 2000 has
been preloaded on it. (Windows 2000 is preloaded on workstation style GWP-W.) Take the
following steps:
1. Run Windows 2000 Professional Setup to configure the workstation with information
local to the site.
2. Configure the display properties.
3. Install and configure Internet Information Services.
4. Install the display software.
These procedures are described in 11.9 through 11.12.
11.10. Installing Windows 2000 on the SPO
Workstation
Take the following steps to configure a workstation on which Windows 2000 has been
preloaded:
1. Power on the workstation.
The system boots, and the Windows 2000 Professional Setup window appears.
2. Click Next.
The License Agreement dialogue box is displayed.
3. Click I accept this agreement, then click Next.
The Regional Settings dialogue box appears.
4. Customize the locale and keyboard settings if the defaults are not correct. (The
dialogue box is self-explanatory.) Then click Next.
A dialogue box labeled Personalize Your Software appears.
5. Enter name and organization as follows:
a. Name field—Enter the user name the site wants identified with the Windows 2000
node.
b. Press the Tab key to advance to the Organization field.
c. Organization field—Enter the organization the site wants identified with the
Windows 2000 node.
d. Click Next to proceed to the next screen.
A dialogue box labeled Computer Name and Administrator Password appears.
6. In the Name field, enter the host name from Table 2–2 by which the SPO workstation
will be identified on the external TCP/IP network.
11–26 Version 009B (Web Only) 7850 5104–009