ClearPath IX Systems Installation and Configuration Guide

About This Guide
Section 15. Installing the Remaining IOE Software
Procedures in this section are performed by site personnel after hardware RFU. This
section describes how to install the remaining IOE software, including OS 2200 server and
Windows workstation software.
Section 16. Customizing the Site
Procedures in this section are performed by site personnel after hardware RFU. This
section describes how to use Integration Expert to configure other software or to create
and populate the IX Network Identity Repository. It also describes how to perform TCP/IP
communications tests, how to customize SPO Basic Edition configurations, and how to
configure resilient partitions.
Section 17. Installing Optional OS 2200 Software from the Package Tapes
Procedures in this section are performed by site personnel after hardware RFU. This
section describes how to register the key tape and points to documentation for installing
more optional products.
Appendix A. Tables of Documentation, Support, and Migration
The tables in this appendix do the following:
• Relate ClearPath components to the levels of the ClearPath IX Installation and
Configuration Guide in which they are documented (Table A–1)
• Summarize the supported combinations of software and Intel processors (Table A–2)
• Summarize the hardware migration requirements for moving from an HMP IX 4.0
server to an HMP IX 5.0 operating system (Table A–3)
Appendix B. Communication Settings Specific to ClearPath IX
This appendix describes required private FDDI interconnect IP addresses and names, and
TSAM configuration values used by the internal network of the server.
Appendix C. SPO/HMP IX Interface License Key Registration
This appendix contains the form used by Single Point Operations Console (formerly known
as SPO/ESE) sites to request the permanent software license key needed to manage the
server using Single Point Operations Console software.
Appendix D. Configuring the FDDI Interconnect
This appendix explains how to create the fiber distributed data interchange (FDDI)
interconnect configuration in the Site Configuration Management System (SCMS) database
if it must be re-created for some reason. The database is provided prebuilt from the
factory so this should not be necessary.
Appendix E. Installing OPE and SysAdmin
This appendix explains how to install Open Programming Environment (OPE) and
SysAdmin, two optional IOE products that are provided with the ClearPath system.
7850 5104–009 Version 009B (Web Only) xxv