ClearPath IX Systems Installation and Configuration Guide

Installing and Configuring SPO Workstation Software
7. Enter the following commands to
• Set the transfer mode to binary.
• Turn off interactive prompting.
• Change to the XVision fonts directory on the SPO server.
• Transfer the font files to the PC.
binary
prompt
mget /opt/SPO/XP/xvfonts/*.*
8. Enter the following commands to exit FTP and the command prompt window:
quit
exit
You now install the new fonts in XVision.
Installing SPO Basic Edition Fonts in XVision
The procedure for making the SPO Basic Edition fonts available to XVision is as follows:
1. Click the right mouse button on the green XVision logo on the right side of the taskbar,
then click Properties.
A Properties for XVision window appears.
2. Click the Fonts tab.
3. Add the new fonts as follows:
a. Click Add.
b. In the Add New Font Path Item window, click Add.
c. In the “Choose a folder of fonts” window, double-click the spofonts folder.
d. With Look in: showing the spofonts directory, and File name: showing fonts or
fonts.dir, click Open.
e. Click Apply, but do not close the Properties for XVision window (do not click OK).
SPO font installation is complete.
Configuring XVision Display, Server, and Security Properties
Follow these steps to configure the XVision display, server, and security properties:
1. Configure display settings as follows:
a. If the Properties for XVision window is not open, right-click the green XVision logo
on the right side of the taskbar, then click Properties.
A Properties for XVision window opens.
b. Click the Display tab (if it is not already the active tab).
c. Click Single window.
11–22 Version 009B (Web Only) 7850 5104–009