ClearPath IX Systems Installation and Configuration Guide

Installing and Configuring SPO Workstation Software
Continue by installing the video driver (11.6).
11.7. Installing the Video Driver on the Windows NT
Workstation
Follow this procedure to install the video driver:
Notes:
• If you received the GWP-1 console type, start at step 1.
• The GWP-1 console video driver requires Service Pack 4 or higher.
• For the CWP console type, start at step 10.
For GWP-1 console type only:
1. Log on to Windows NT (11.14.2) and insert the ATI Installation CD-ROM International
into the drive.
The ATI Installation program starts automatically.
2. Click Easy Install.
3. Click Next.
4. Select I agree, then click Next.
5. Select Express Setup if it is not already selected, then click Finish.
A message appears when the installation finishes:
Install completed successfully.
6. Click OK.
A message asks if you wish to restart the computer.
7. Remove the CD-ROM from the drive and click Yes.
The system reboots.
8. When the reboot is done, log on to Windows NT again.
An Invalid Display Settings window appears.
9. Click OK.
A window appears for configuring the video display.
For both GWP-1 and CWP console types:
10. Configure the video display as follows:
Note: If the Display Properties window is not on the screen, right-click anywhere
on the desktop, then click Properties in the pop-up menu that appears.
a. Move the Desktop Area slider to the right to select 1280x1024 pixels.
11–18 Version 009B (Web Only) 7850 5104–009