ClearPath IX Systems Installation and Configuration Guide

Installing SPO Basic Edition and Related Software
10.15. Logging On to UnixWare
Caution
To prevent unauthorized access to the UnixWare node following initial installation,
the site must change the default password to a different password.
Note: Switch the monitor concentrator to the SPO_Server position before beginning
(see 2.5.2).
Several installation and configuration procedures require you to log on as the root user
(user-id root). Root logon also provides superuser privileges.
Before you start, press any key to stop the screen saver, if it is running.
If the root prompt (#) is showing, you are already logged on as the root user (superuser).
10.15.1. Switching Windows
You can switch between graphical mode and console(character) mode, and switch among
all configured windows, by using these control key combinations:
Ctrl-Alt-Esc Console (character) mode
Ctrl-Alt-F1 Graphical mode
Ctrl-Alt-F2 through F8 Character-mode virtual terminals
10.15.2. Logging On As the Root User (Superuser) in Graphical
Mode
Ensure you are in graphical mode by pressing Ctrl-Alt-F1. When UnixWare displays the
graphical user interface (GUI) logon screen, log on as follows:
1. In the Login ID field, enter root.
2. In the Password field, enter unisysas.
3. Click Login or press Enter.
The UnixWare graphical desktop appears following this logon.
10.15.3. Logging On As the Root User (Superuser) in Character
Mode
Ensure you are in the console session by pressing Ctrl-Alt-Esc. Then log on as follows:
1. At the console login prompt, enter root.
10–28 Version 009B (Web Only) 7850 5104–009