ClearPath IX Systems Installation and Configuration Guide

Installing SPO Basic Edition and Related Software
Note: Do not forget the root account password. If you forget this password, you
must completely reinstall the system to set up a new one.
38. View the license terms, select Accept, and press F10 when you are finished.
The following prompt appears:
If you are ready to install the system, press F10.
Note: If you need to change any information in the installation, you can step back
through the installation by pressing F9.
39. Continue the installation by pressing F10.
The software load begins. This process typically takes less than 40 minutes. The
software load can continue unattended.
During the software load, you can track the progress of the installation by viewing
progress indicators that are displayed for each package loaded.
You are prompted to insert the HBA diskette when the software load is completed.
40. Insert the host bus adapter diskette (labeled “Unisys UnixWare 7.x.x Operating System
PSK/UNX7-PSK Host Bus Adapter (HBA)”) into the drive and press Enter.
The kernel (/stand/unix) is rebuilt. This process takes several minutes. A message is
displayed when the kernel is successfully rebuilt.
41. Remove all diskettes, tapes, and CD-ROMs.
42. Press any key to reboot the UnixWare 7 system.
After the system reboots, a Mouse Selection screen appears.
43. Configure the mouse as follows:
a. Tab to select the PS/2-compatible mouse, then press F10.
b. The default number of buttons is two. Press F10.
c. Press Enter to start the mouse test.
d. Move the mouse.
e. Press a mouse button to end the test.
When you are finished testing the mouse, the following message appears:
To continue installing the system, insert CD-ROM #2 and press .
44. Insert the CD-ROM and press F10.
45. When the window “Select products to install” appears, press Enter. This process
typically takes less than 30 minutes.
46. When the window “The following products were successfully installed:” appears, press
F10.
47. Another message appears asking for CD-ROM #3. Press F8.
The system automatically boots into multi-user mode.
Installation of the UnixWare 7 operating system is now complete.
Continue by installing the PSK updates (10.5).
10–12 Version 009B (Web Only) 7850 5104–009