ClearPath IX Systems Installation and Configuration Guide

Installing SPO Basic Edition and Related Software
Notes:
• To change the type to vxfs, as instructed above, press F2, tab to vxfs, and press
Enter.
• For Root File System (/), above, adjust Size for root so that Allocated (MB) is not
greater than Available (MB).
Change the values as follows:
• Boot File System (/stand)—Accept the default; do not change the size.
• Swap Slice (/dev/swap)—Accept the default; do not change the size.
• User File System (/home)— Accept the default; do not change the size.
• Second User File System (/home2)—Change the type to vxfs and the size to 2048.
• Var File System (/var)— Accept the default; do not change the size.
• Temporary File System (/tmp)—Leave the type as memfs; change the size to 100.
• Temporary File System (/var/tmp)—Leave the type as memfs; change the size to
50.
• Root File System (/)—Change Size to the size of the remaining space. Keep the file
system type default (vxfs).
For the rest of the settings, accept the defaults.
21. Press F10.
The following menu appears:
Choose one
(*) Use default disk options
( ) Customize disk options
22. Select Use default disk options and press F10.
The Choose System Profile menu appears.
23. Customize your configuration as follows:
a. Select Customize Installation of Packages and press F10.
b. Select Core System Services and press F10.
c. Select Extended OS Utilities and press F2.
d. Select Select all packages (FULL) and press Enter.
e. Verify that State of Extended OS Utilities Service is set to Full.
f. Press F10.
g. Select Accept current selection and continue, then press F10.
The Choose Platform Support Module menu appears.
24. Select a platform support module:
a. Press PageDown.
b. Tab to Install No PSM at This Time.
c. Press Enter.
10–10 Version 009B (Web Only) 7850 5104–009