ClearPath IX Systems Installation and Configuration Guide

Installing SPO Basic Edition and Related Software
8. Remove the boot diskette from the drive.
9. Insert the host bus adapter diskette (labeled “Unisys UnixWare 7.x.x Operating System
PSK/UNX71-PSK Host Bus Adapter (HBA)”) into the drive.
10. Press F10.
After the diskette is loaded, you are prompted to install additional HBA diskettes.
11. Remove the HBA diskette from the drive.
12. Select Proceed with Installation and press F10.
The Device Configuration Utility (DCU) window appears.
13. Select Do Not Enter the DCU (auto-configure drivers).
14. Press F10.
The following message appears:
Please wait while the system hardware drivers are loaded
You are prompted for the node name of the system.
15. Obtain the node name of the system from the customer. Enter the node name and
press F10.
Note: Do not enter a fully qualified node name that includes the domain. You can
enter the domain name later during network configuration.
The Select Installation Method menu appears.
16. Insert the Business Edition CD-ROM 1 of 3 into the drive.
17. Select Install from CD-ROM and press F10.
The following message appears:
Please wait while the installation media (cdrom) is verified
Then the following menu appears:
Disk Configuration
Disk No. Character Node Action
======== ========= ==== ======
1 /dev/rdsk/c0b0t0d0s0 Use whole disk for Unix
18. Select Use whole disk for Unix. This uses the whole disk for UnixWare 7 and removes
all data on existing partitions.
19. Press F10.
The following menu appears:
Choose one
(*) Use default filesystem sizes and types
( ) Customize filesystem and slices
20. Select Customize file system and slices and press Enter.
The screen values to change are shown below.
7850 5104–009 Version 009B (Web Only) 10–9