ClearPath IX Systems Installation and Configuration Guide

Installing SPO Basic Edition and Related Software
10.2. Determining Whether Software Is Preinstalled
Caution
To prevent installation problems, or wasted time, determine whether or not
UnixWare has been preinstalled. Then follow either the procedure for preinstalled
software or the full installation procedure, as appropriate.
Updated information may be available in the Web version of this document:
http://public.support.unisys.com/os1/txt/web-verity?type=list
To determine if UnixWare is preinstalled, power on the system. If UnixWare is
preinstalled, the system boots. Otherwise, the system displays the following error
message:
Missing operating system
Cannot boot UnixWare.
If UnixWare is preinstalled, perform the steps in 10.3.
If UnixWare is not preinstalled, perform the steps from 10.4 through 10.14.
Note: When booting the SPO server for the first time or two, you may see an error
message saying, “Could not modify qmon1a about modified data, try running
SACADM -x -pqmon1a.” A message similar to this usually appears. It concerns
the initialization of the multiport asynch card and can be ignored.
10.3. Steps to Take If Software Is Preinstalled
Note: Perform this procedure only if the UnixWare operating system has been
installed at the factory (you have not installed the operating system).
If the UnixWare operating system is preinstalled, you must do the following steps:
10.3.1. Entering the License
Follow these steps to enter the license information.
1. At the console screen, log on as the root user (user-id root) in graphical mode
(10.15.2).
loginid: root
pswd: unisysas
2. In the terminal window, enter scoadmin. A System Administration window appears.
3. Double-click License Manager.
4. Click License.
10–4 Version 009B (Web Only) 7850 5104–009