ClearPath IX Systems Installation and Configuration Guide

Installing UnixWare 7
39. Press any key to reboot the UnixWare 7 system.
After the system reboots, a Mouse Selection screen appears.
40. Configure the mouse as follows:
a. Tab to select the PS/2-compatible mouse, then press F10.
b. The default number of buttons is two. Press F10.
c. Press Enter to start the mouse test.
d. Move the mouse.
e. Press a mouse button to end the test.
When you are finished testing the mouse, the following message appears:
To continue installing the system, insert CD-ROM #2 and press .
41. Insert the CD-ROM and press F10.
42. When the window “Select products to install” appears, press Enter.
43. At Enhanced Event Logging System Installation, Enter Default Database Location
window, tab to apply and press Enter.
44. When the window “The following products were successfully installed:” appears,
press F10.
45. Another message appears asking for CD-ROM #3. Press .
The system automatically boots into multi-user mode.
Installation of the UnixWare 7 operating system is now complete.
Continue by installing the UnixWare and Open Server Development Kit (8.4.2).
8.4.2. Installing the UnixWare and Open Server Development Kit
(UDK)
Note: This procedure is required for each ClearPath IX node running the UnixWare 7
operating system.
To install the UnixWare and OpenServer Development Kit (UDK):
1. Log on as the root user (user-id root) (8.12.1).
2. Insert the UnixWare 7 UnixWare and OpenServer Development Kit (UDK) CD-ROM
into the CD-ROM drive.
3. From the command line at the root directory, type the following command, and press
Enter:
pkgadd -d cdrom1
4. Press Enter to continue.
You receive a message asking you not to remove the CD-ROM from the drive. Then
you are prompted to select the package you want to add (there is only one).
7850 5104–009 Version 009B (Web Only) 8–21