ClearPath IX Systems Installation and Configuration Guide

Installing UnixWare 7
Then the following menu appears:
Disk Configuration
Disk No. Character Node Action
======== ========= ==== ======
1 /dev/rdsk/c0b0t0d0s0 Use whole disk for Unix
18. Configure up to two detected hard disks. Do the following for each disk you
configure:
a. Use the Tab key to select the disk to configure.
b. For the first disk, select Use whole disk for Unix. This uses the whole disk for
UnixWare 7 and removes all data on existing partitions.
c. For the second disk (optional), you can select Do not modify.
After you have selected the options for the disks you want to configure, press F10.
The following menu appears:
Choose one
(*) Use default filesystem sizes and types
( ) Customize filesystem and slices
19. Select Customize filesystem and slices, press Enter.
Change the values on the screen as shown below.
Note: To change the type to vxfs, as instructed below, press F2, tab to vxfs, and
press Enter.
For a 9-GB disk:
• Root File System (/)—Change size to 2048. Keep the file system type default
(vxfs).
• Boot File System (/stand)—Accept the default; do not change the size.
• Swap Slice (/dev/swap)—Accept the default; do not change the size.
• User File System (/home)—Change the type to vxfs (see note above) and the size
to 2048.
• Second User File System (/home2)—Change the type to vxfs and the size to 2048.
• Var File System (/var)—Change the type to vxfs and the size to the remaining disk
space.
For the rest of the settings, accept the defaults.
For an 18-GB disk:
• Root File System (/)—Change size to 9654. Keep the file system type default
(vxfs).
• Boot File System (/stand)—Accept the default; do not change the size.
• Swap Slice (/dev/swap)—Accept the default; do not change the size.
• User File System (/home)—Change the type to vxfs (see note above) and the size
to 2048.
• Second User File System (/home2)—Change the type to vxfs and the size to 2048.
8–18 Version 009B (Web Only) 7850 5104–009