ClearPath IX Systems Installation and Configuration Guide

Installing UnixWare 7
17. Change the write policy for the drive from write-through (write cache not enabled) to
write-back (write cache enabled) as follows:
a. Select 2 (Toggle Write Policy) from the System Drive Definition menu, then press
Enter.
The cursor jumps to the Write Mode column in the system drive table.
b. Press Enter to toggle the write mode.
18. Press Esc to return to the System Drive Definition menu; then press Esc twice again to
return to the Main Menu.
A confirmation window appears asking whether you want to save the configuration.
19. Select Yes, then press Enter.
The configuration is saved, and you are notified that drive 0 is available for immediate
use.
20. Press Enter to continue.
The Main Menu is redisplayed.
Main Menu
01. Automatic Configuration
02. New Configuration
03. View/Update Configuration
04. Rebuild
05. Initialize System Drive
06. Consistency Check
07. Tools
08. Select DAC960
09. Advanced Functions
10. Diagnostics
21. Select 05 (Initialize System Drive), then press Enter.
The Initialize System Drive menu appears.
Initialize System Drive
1. Select System Drive
2. Start Initialize.
22. Select 1 (Select System Drive), then press Enter.
A screen appears that lists all of the defined system drives on the left side. The
following messages appear on the right side and below the list:
More than one System Drive can be
initialized simultaneously. Select
to start initialization of the selected
System drives.
!!WARNING!! Initialization of the System
Drives will destroy data on the drives.
Select System drive(s) using cursor keys, hit , to Previous
Menu
7850 5104–009 Version 009B (Web Only) 8–11