ClearPath IX Systems Installation and Configuration Guide

Installing UnixWare 7
c. Repeat steps a and b for drive 2,1.
You are returned to the Pack Definition menu.
10. Press Enter to select the Arrange Pack option.
The cursor moves to the drive matrix.
11. Press Enter again to arrange the pack.
The pack being arranged moves to the pack table on the screen and the New
Configuration menu is redisplayed.
New Configuration
1. Define Pack
2. Define System Drive
12. Select 2 (Define System Drive), then press Enter.
Two tables are displayed on the left side of the screen. The top left table lists all the
arranged packs and their sizes. The bottom left table is empty (no system drives have
been defined).
A System Drive Definition menu is displayed on the right side as follows:
System Drive Definition
1. Create System Drive
2. Toggle Write Policy
13. Select 1 (Create System Drive), then press Enter.
All arranged packs that are not part of a system drive are selected for the system drive.
A RAID Level window is displayed:
RAID Level
RAID 0
RAID 1
RAID 5
RAID 6
RAID 7
14. Select RAID 1, then press Enter.
A window appears that displays the maximum possible size for the system drive to be
defined.
15. Press Enter to use the entire disk.
An information window describes the drive being created, followed by a confirmation
window.
16. Select Yes, then press Enter.
The system drive is created and the system drive table on the bottom left is updated.
8–10 Version 009B (Web Only) 7850 5104–009