ClearPath IX Systems Installation and Configuration Guide

Installing UnixWare 7
2. Start the DACCF utility by typing DACCF and pressing Enter:
DACCF
Note: If more than one DAC is installed, a list is displayed so you can select the
DAC to be configured.
The DACCF utility Main Menu should appear as follows:
Main Menu
01. Automatic Configuration
02. New Configuration
03. View/Update Configuration
04. Rebuild
05. Initialize System Drive
06. Consistency Check
07. Tools
08. Select DAC960
09. Advanced Functions
10. Diagnostics
If you get an Installation Aborted message and a list of detected drives instead of the
menu, take the following steps:
a. Press any key to proceed. A drive matrix appears, showing the current
configuration (Figure 8–1).
b. Press S to save the current configuration.
A message indicates you should reboot.
3. Reboot and reload the DACCF utility.
a. Reboot.
b. Insert a DOS-bootable diskette.
c. When the MS-DOS prompt appears, remove the diskette and insert the diskette
labeled “DACCF CONFIGURATION AND UTILITIES” in drive A.
4. Change directories on the A drive by typing CD DACCFG, then press Enter.
CD DACCFG
5. Start the DACCF utility by typing DACCF and pressing Enter:
DACCF
6. In the DACCF utility Main Menu, use the arrow keys to select 02 (New Configuration),
then press Enter.
The New Configuration menu appears as follows:
New Configuration
1. Define Pack
2. Define System Drive
8–8 Version 009B (Web Only) 7850 5104–009