ClearPath IX Systems Installation and Configuration Guide

Installing UnixWare 7
8.2.3. Changing the Date and Time Zone
Follow these steps to change the date and time zone.
1. Open the SCO Admin window.
2. Scroll to the System folder and double-click.
3. Double-click System Time Manager.
4. Click Host.
5. Click Change Time Zone.
6. Select the appropriate country and time zone and click OK.
7. After reading the time zone change message, click OK.
8. Click Host.
9. Click Set Time.
10. Enter the correct time and date. Click OK.
11. Click OK when the message appears saying the system time will change.
12. In the upper left-hand side of the window, click Host.
13. Click Exit.
14. In the SCO Admin window, click File and then Exit.
15. Click Exit on the lower bar and then click OK to log off.
16. Perform all of these tasks as described in other subsections:
a. Configure the Ethernet and FDDI network adapters (8.6.1).
b. Configure a domain name service client (8.6.2).
c. Set up the documentation search engine (8.7).
d. Run the tuning script (8.8).
Note: Answer Y to “Did you install the OS?”
e. Retrieve and apply fixes (8.9)
f. Configure Internet FastStart (8.10).
After you have completed all these steps, you are returned to the terminal session
prompt.
17. Enter the following command to reboot:
# shutdown- y - g0 - i6
Reboot takes about 7 minutes. When it is done, UnixWare displays the GUI logon
screen.
18. Log on as the root user (user-id root) (8.11.1).
The UnixWare root prompt (#) appears. Procedures for preloaded UnixWare 7
configuration are completed at this point.
8–6 Version 009B (Web Only) 7850 5104–009