ClearPath IX Systems Installation and Configuration Guide

8.2. Steps to Take If Software Is Preloaded
Installing UnixWare 7
If the UnixWare operating system is preloaded, take the steps in 8.2.1 through 8.2.3.
Notes:
• Perform this procedure only if the UnixWare operating system was loaded at the
factory (you have not copied the operating system from the installation CD-ROM.
• If you decide to perform a full installation even though the system is preloaded, do
not format the RAID disk. Instead, use the DAC BIOS utility to initialize the RAID
volume before you reload the operating system. Formatting the disk makes the drive
unrecognizable to the software.
8.2.1. Entering the License
Follow these steps to enter the license information.
1. At the console screen, log on as the root user (user-id root) (8.12.1).
loginid: root
pswd: unisysas
2. In the Task bar, click the second arrow from the right (above the fifth icon from the
right) to present the SCO menu.
3. Click SCO Admin.
4. Double-click License Manager.
5. Click License.
6. Click Add.
7. Enter License Info. Click License button.
8. Click OK.
9. If you have a license for the UDK or any other additional licenses, enter them now by
repeating steps 4 through 7.
10. When you have finished entering licenses, click Host, then click Exit.
8.2.2. Changing the Host Name
Follow these steps to change the host name.
1. Open the console terminal window by clicking the dtterm icon in the upper left-hand
corner.
2. Type setuname -n newsystemname and press Enter.
3. Type uname -a to verify the new system name.
7850 5104–009 Version 009B (Web Only) 8–5