ClearPath IX Systems Installation and Configuration Guide

Completing Windows Installation
To apply the service pack for Windows NT Server 4.0
1. Insert the service pack CD-ROM (labeled “Windows NT Service Pack n”) into the drive
unit. Internet Explorer should start automatically, and a Service Pack home page
should appear. (See the note below for the exception.)
Note: If Internet Explorer does not start automatically, take the following steps:
a. Click Start, then Run.
A Run window appears.
b. In the Run window, type the following, then click OK:
d:\spsetup
c. Skip to step 3.
2. Click the Install Service Pack n link, then
• (IE 4.01 and higher) Select “Run this program from its current location” and
click OK.
• (IE 3.02) Select “Open it” and click OK.
A Welcome screen appears.
3. A License Agreement screen appears.
4. Click the check box to accept the license agreement. Uncheck the backup-files box.
5. Click the Install button.
Files are copied and the service pack is installed. During installation, a Windows NT
Service Pack Setup window may appear, listing the name of a file with the following
message:
This file has been identified as an oem-installed file.
Would you like to overwrite the version of the file on your system with
the Service Pack n version?
6. Click No for all file messages that may appear.
When setup finishes, a prompt appears to reboot the server.
7. Click Restart.
8. After the server finishes rebooting, log on as Administrator.
9. If a NO button appears, click it to view Y2K.txt message. Otherwise skip to 7.1.16.
10. Apply the Y2K DAO update.
a. Click Start, then Run.
b. Type D:\I386\update\y2ksetup.
c. Click Yes to install these programs now.
d. After update completes, click OK to restart the computer. Remove the CD media.
e. After server reboots, log on as Administrator. The Y2K update will finish.
Continue with 7.1.16.
7–18 Version 009B (Web Only) 7850 5104–009