ClearPath IX Systems Installation and Configuration Guide

Section 7
Completing Windows Installation
This section describes how to finish installing and configuring software on either a
Windows NT node or a Windows 2000 Node.
For Windows NT, carry out the steps in 7.1. For Windows 2000, proceed to 7.2.
Table 7–1 lists procedures that require you to have information or installation media
available at the time of installation. Obtain these materials before beginning.
Table 7–1. Checklist for Completing Windows NT Installation
ß Media or Information Required
7.1.1. Installing Service Pack 3 for Windows NT
Media needed:
For ES5044R, Aquanta ES2045R, Aquanta ES2085R, or Aquanta ES5085R: Windows NT Server,
Enterprise Edition, Disk 1 (CD-ROM)
For Aquanta DR/2: Service pack CD-ROM—labeled “Windows NT Service Pack n”
7.1.2. Installing the Unisys Hardware Monitor (DR/2 Only)
Media needed: Unisys Hardware Monitor Service diskette—labeled “Unisys Hardware Env Service
(part number 38164992-002)”
7.1.3. Configuring ClearPath Networking
Media needed: Windows NT installation tools diskette—labeled “NT Installation Tools”
The Windows NT installation tools diskette is provided as part of the server IOE.
7.1.5. Installing and Configuring RAID Utility Software
Media needed:
For a DR/2 node: RAID controller software diskette—labeled “Windows NT 4.0/3.51 Driver
MEGARAID.SYS...” Disks 1 and 2 (ES2045R or DR/2)
For an ES5044R, ES5085R, or ES3045R node: RAID controller software CD—labeled "Mylex Solutions
Software Kit x.x "
7.1.6. Installing and Configuring Video Drivers (Full Install Only)
Media needed: Video driver diskette—labeled “Unisys Supplemental Drivers and Utilities CD,” part
number 23387707- xxx
continued
7850 5104–009 Version 009B (Web Only) 7–1