ClearPath IX Systems Installation and Configuration Guide

Installing Windows NT Server 4.0 (DR/2)
b. Click the IP Address tab, then enter the following IP address information:
1) Click Specify an IP address.
2) In the IP Address field enter the IP address for the Windows NT node from
Table 2–2, then press Tab.
3) Change the subnet mask to the netmask address from Table 2–2, or skip this
field (accept the default).
4) If you have a gateway (router), click Advanced (otherwise skip this step) and
take the following steps:
a) Click Add.
b) In the New Gateway field, type the gateway address from Table 2–2.
c) Click Add.
The address appears in the Installed gateways: list box.
d) Repeat these steps for each additional gateway required, then click OK
when done.
c. If the site chooses to implement WINS, click the WINS Address tab (otherwise
skip this step), then enter the following WINS information:
Note: Be sure the Ethernet adapter is selected, and not the FDDI adapter.
WINS is not used on the FDDI interconnect.
1) In the Primary WINS Server field, type the address from Table 2–2, then press
Tab.
2) If applicable, type the IP address of the Secondary WINS Server from Table
2–2.
d. Click the DNS tab and take the following steps:
1) Enter the IP address for the first DNS server from Table 2–2, if the site has any
DNS servers.
2) Click Add.
The DNS address is added to the search order list box.
3) Repeat these steps for each additional DNS server.
4) Enter a domain name, if possible, for proper operation of the IIS services.
27. Click OK.
The following message appears:
At least one adapter cards has an empty WINS address.
Do you want to continue?
28. Click YES.
A screen appears that allows you to confirm the network bindings.
29. Click Next to proceed.
A screen appears indicating that Windows NT is ready to start the network.
30. Click Next to proceed.
6–20 Version 009B (Web Only) 7850 5104–009