ClearPath IX Systems Installation and Configuration Guide

Installing Windows NT Server 4.0 (DR/2)
A screen appears for setting the Intel Pro 100. Click OK to continue.
22. Installation of networking components begins. A message box asks if you want to use
Dynamic Host Configuration Protocol (DHCP) server.
23. Click No.
Messages indicate software is being installed. After about 1 minute, you are prompted
with a tabbed SNMP Properties screen.
24. Set the SNMP properties as follows:
a. Agent tab—Click this tab, then enter the name, room number, and phone number
of the system administrator. Accept the service defaults (Applications, Internet,
and End-to-End).
b. Security tab—Click this tab, then click the Send Authentication trap check box to
remove the check mark. Leave the Accept SNMP Packets from Any Host option
set.
c. Click OK.
d. If you select IPX/SPX protocol (see step 16), you are prompted to assign a unique
network number to one of the adapters.
After about a minute, a tabbed Microsoft TCP/IP Properties screen appears.
25. Configure the FDDI network adapter card as follows:
a. Use the scroll bar to select the following adapter from the drop-down list of
adapters:
SK-NET FDDI PCI Adapter
b. Click the IP Address tab, then enter IP address information as follows:
1) Click Specify an IP address to select it.
Note: You must know if this Windows 2000 or NT server node is being
installed as the first, second, third, or fourth Windows node in the
ClearPath IX system to which it is connected. You will use the IP
address associated with that node number. The addresses are listed
in Table B-1.
2) In the IP Address field, type the appropriate FDDI address for this node (for
example, 192.168.057.003 for the first Intel node) as described in Appendix B,
then press Tab.
3) In the Subnet Mask field, enter the address 255.255.255.0.
c. Click the Advanced button.
1) Click the Add button in the IP Addresses box.
2) Enter the other two addresses and subnet masks for Windows NT.
3) Click OK.
26. Configure the Ethernet network adapter card as follows:
a. Use the scroll bar to select the following adapter from the drop-down list of
adapters:
Intel EtherExpress PRO Adapter
7850 5104–009 Version 009B (Web Only) 6–19