ClearPath IX Systems Installation and Configuration Guide

Installing Windows NT Server 4.0 (DR/2)
c. Organization field—Enter the organization responsible for the Windows NT node.
d. Click Next to proceed to the next screen.
A registration screen appears asking for the registration number from the
Certificate of Authentication.
5. Enter the registration number as recorded in Table 2–2, or directly from the Certificate
of Authentication, as follows:
a. Type the required digits in each field.
b. Click Next to proceed.
A Licensing Modes screen appears.
6. Click the Per Seat licensing option, then click Next to proceed.
The Computer Name screen appears.
Note: This name (up to 15 characters) is the Network Basic Input/Output System
(NETBIOS) name that uniquely identifies the computer in the Windows NT
workgroup or domain. It must be different from the workgroup or domain
name.
7. In the Name field, enter the host name from Table 2–2 by which the Windows NT node
will be identified on the external TCP/IP network. Click Next to proceed to the next
screen.
The Server Type screen appears.
Note: In the following step, the client may elect to install as a primary domain
controller (PDC) or backup domain controller (BDC), rather than standalone
server; however, additional steps must be taken which are not
described in this procedure (see Table 6–1).
8. Click Standalone Server (or the selection from Table 6–1), then click Next to proceed.
The Administrator Account screen appears.
9. Enter and confirm the password for the administrator’s account as follows:
a. In the Password field, type the password administrator.
b. Press the Tab key to go to the Confirm Password field. Type administrator in
that field.
c. Click Next to proceed.
Note: Following installation, the site must change the default password
(administrator) to a different password.
An Emergency Repair Disk screen appears.
10. Click No. Then click Next to proceed.
Note: You will create the emergency repair disk later. Have a labeled diskette
ready for that purpose.
The Select Components screen appears with the following defaults selected:
• Accessibility options
• Accessories
6–16 Version 009B (Web Only) 7850 5104–009