ClearPath IX Systems Installation and Configuration Guide

Installing Windows NT Server 4.0 (DR/2)
A message indicates that the disk is being formatted. After the disk is formatted, a
message appears asking for the directory in which to install Windows NT.
18. Press Enter to accept the default directory (WINNT).
A message asks whether you want an exhaustive examination of the hard drives.
19. Press Enter to perform an exhaustive examination of the hard disk. The examination
takes a few seconds.
20. Unless you removed it, the diskette you need is already in the drive. If it is not,
reinsert the following:
Mylex Solution Software Kit 2.01 NT/NW Drivers Diskette
Setup begins copying files. When done, a message asks you to remove the diskette in
preparation for rebooting.
21. Remove the diskette and the CD-ROM from the drive units, then press Enter.
Two reboots occur. First Windows NT boots using the file allocation table (FAT) file
system. Then the FAT file system is converted to the desired NTFS and Windows NT
reboots again.
Following reboot, the Windows NT Setup GUI screen appears. Continue by configuring
Windows NT as described in 6.4.2.
6.4.2. Configuring Windows NT Server 4.0
Note: This procedure follows immediately after, and is continuous with, the
installation procedure in 6.4.1.
After the Windows NT operating system reboots (6.4.1), a Windows NT Setup screen
appears with a message box saying to insert the Windows NT CD-ROM. Take the following
steps:
1. Insert the Windows NT CD-ROM (labeled “Microsoft Windows NT Server”) into the
drive unit, then click OK.
A prompt indicates files are needed from the Windows NT Server CD-ROM. A scroll
box identifies the directory from which they will be copied.
2. Click OK to proceed.
After a few seconds, a Windows NT Setup screen indicates that setup includes
• Gathering information about your computer
• Installing Windows NT networking
• Finishing setup
3. Click Next to proceed to the next screen.
A Name and Organization screen appears.
4. Enter the Name and Organization responsible for the node as follows:
a. Name field—Enter the name of the person responsible for the node.
b. Press the Tab key to advance to the Organization field.
7850 5104–009 Version 009B (Web Only) 6–15