ClearPath IX Systems Installation and Configuration Guide

Installing Windows NT Server 4.0 (DR/2)
1) Click the Add button in the IP Addresses box.
2) Enter the other two addresses and subnet masks for Windows NT from Table
B–1.
3) Click OK.
19. Configure the Ethernet network adapter card as follows:
a. Use the scroll bar to select the following adapter from the drop-down list of
adapters:
Intel EtherExpress Pro Adapter
b. Click the IP Address tab, then enter the following IP address information:
1) Click Specify an IP address.
2) In the IP Address field enter the IP address for the Windows NT node from
Table 2–2, then press Tab.
3) Change the subnet mask to the netmask address identified in Table 2–2, or
skip this field (accept the default).
4) If you have a gateway (router), click Advanced and take the following steps:
a) Click Add in the gateways section.
b) In the gateway address field, type the gateway address identified in Table
2–2.
c) Click Add.
The address appears in the gateways list box.
d) Repeat these steps for each additional gateway required, then click OK
when done.
c. If the site chooses to implement WINS, click the WINS Address tab (otherwise
skip this step), then enter the following WINS information:
1) In the Primary WINS Server field, type the address identified in Table 2–2, then
press Tab.
2) If applicable, type the IP address of the Secondary WINS Server identified in
Table 2–2.
d. Click the DNS tab and take the following steps:
1) Enter the IP address for the first DNS server from Table 2–2, if the site has any
DNS servers.
2) Click Add.
The DNS address is added to the search order list box.
3) Repeat these steps for each additional DNS server.
4) Enter a domain name, if possible, for proper operation of the IIS services.
e. Click the Routing tab. Then click “Enable IP forwarding” to clear the check box if
it is not already clear. This ensures the security of the HMP interconnect. You
must not enable IP forwarding
6–8 Version 009B (Web Only) 7850 5104–009