ClearPath IX Systems Installation and Configuration Guide

Installing Windows NT Server 4.0 (DR/2)
13. Enter and confirm the password for the administrator’s account as follows:
a. In the Password field, type the password administrator.
b. Press the Tab key to go to the Confirm Password field. Type administrator in
that field.
c. Click Next to proceed.
Note: Following installation, the site must change the default password
(administrator) to a different password.
After about 1 minute, a Windows NT Setup screen for configuring networking appears.
14. Click Next.
After a brief wait during which the setup program searches for network adapters, the
following message appears:
SK-NET FDDI PCI Adapter Card Setup
Continue Cancel Help
15. Click Continue.
Intel Pro 100 is detected on the DR/2.
16. Click Close.
An error message appears as follows:
The IP Address key has an invalid IP address.
Please correct the problem after the property
sheet is displayed.
17. Click OK.
After about 1 minute, a tabbed Microsoft TCP/IP Properties screen appears.
18. Configure the FDDI network adapter card as follows:
a. Use the scroll bar to select the following adapter from the drop-down list of
adapters:
SK-NET FDDI PCI Adapter
b. Click the IP Address tab, then enter IP address information as follows:
1) Click Specify an IP address (a dot appears in the circle to indicate it is
selected).
Note: You must know if this Windows 2000 or NT server node is being
installed as the first, second, third, or fourth Windows node in the
ClearPath IX system to which it is connected. You will use the IP
address associated with that node number. The addresses are listed
in Table B-1.
2) In the IP Address field, type the appropriate FDDI address for this node (for
example, 192.168.057.003 for the first Intel node) as described in Appendix B,
then press Tab.
3) A default address of 255.255.255.0 is automatically calculated for the Subnet
Mask field. Do not change that address.
c. Click the Advanced button.
7850 5104–009 Version 009B (Web Only) 6–7