ClearPath IX Systems Installation and Configuration Guide

Installing Windows NT Server, Enterprise Edition (ES2045R)
b. Use the scroll bar to select the Intel EtherExpress PRO adapter from the dropdown
list of adapters.
c. Enter the following IP address information:
• Click Specify an IP address.
• In the IP Address field enter the IP address for the Windows NT node from
Table 2–2, then press Tab.
• Change the subnet mask to the netmask address from Table 2–2, or skip this
field (accept the default).
• If you have a gateway (router), click Advanced (otherwise skip this step) and
take the following steps:
− Click Add.
− In the New Gateway field, type the gateway address from Table 2–2.
− Click Add.
The address appears in the Installed gateways list box.
− Repeat these steps for each additional gateway required, then click OK
when done.
d. If the site chooses to implement WINS, click the WINS Address tab (otherwise
skip this step), then enter the following WINS information:
Note: Be sure the Ethernet adapter is selected, and not the FDDI adapter.
WINS is not used on the FDDI interconnect.
• In the Primary WINS Server field, type the address from Table 2–2, then press
Tab.
• If applicable, type the IP address of the Secondary WINS Server from Table
2–2.
e. Click the DNS tab and take the following steps:
• Enter the IP address for the first DNS server from Table 2–2, if the site has any
DNS servers.
• Click Add.
The DNS address is added to the search order list box.
• Repeat these steps for each additional DNS server.
• Enter a domain (Internet) name to which the server belongs, for proper
operation of the IIS services.
26. Click YES.
A screen appears that allows you to confirm the network bindings.
27. Click Next to proceed.
A screen appears indicating that Windows NT is ready to start the network.
28. Click Next to proceed.
29. A setup screen identifies the host name of the Windows NT node and asks whether the
node is to participate in a workgroup or domain.
7850 5104–009 Version 009B (Web Only) 5–23