ClearPath IX Systems Installation and Configuration Guide

Installing Windows NT Server, Enterprise Edition (ES2045R)
8. Press Enter to continue.
You are prompted to insert disk 3 as follows:
Windows NT Server Setup
=======================
Please insert the disk labeled
Windows NT Server Setup Disk #3
into Drive A:
*Press ENTER when ready
9. Insert the diskette labeled “1-8 CPU Edition Setup Disk 3” into the drive, then press
Enter to continue.
The following message appears at the top of the screen, followed by a message
confirming that the adapters have been recognized.
Windows NT Server Setup
=======================
Setup has detected that one or more of your hard disks has more than 1024
cylinders
10. Press Enter again.
Note: You may be prompted to insert the CD-ROM, if you did not do so as
instructed in step 1.
A message states that Setup has detected that your computer’s hard disk is new.
11. Press C to continue.
A license agreement text screen then appears.
12. Read the contents of the license agreement as follows:
a. Read the contents of the first page, then press the Page Down key to read the next
page.
b. When you reach the last page, press F8 to indicate that you agree with the terms of
the license agreement .
A hardware and software components list appears for you to verify.
13. Be sure that the Computer line reads “MPS Multiprocessor PC.” If it does not, use the
arrow keys to move to that line, press Enter and change as needed.
14. Press Enter to continue.
A screen appears that identifies the unpartitioned disk space.
5–16 Version 009B (Web Only) 7850 5104–009