ClearPath IX Systems Installation and Configuration Guide

Installing Windows NT Server, Enterprise Edition (ES2045R)
5. Enter S to skip autodetection and manually select the SCSI adapter.
A screen appears to indicate that no adapter has been found or selected.
6. Enter S to manually specify the SCSI adapter.
A window for selecting an adapter appears.
7. Select adapters in that window as follows:
a. Press Enter to select the highlighted Other entry. You are prompted to insert a
diskette containing the controller drivers diskette.
Windows NT Server Setup
=======================
Please insert the disk labeled
Manufacturer - supplied hardware support disk
into Drive A:
*Press ENTER when ready
b. Insert the diskette containing the RAID drivers labeled “Windows NT 4.0/3.51
Driver MEGARAID.SYS...” (Disk 1 of 2) and press Enter to continue.
After a brief wait, the MEGARAID NT SCSI driver is listed in the adapter window.
c. Press Enter to select the highlighted MEGARAID NT SCSI Driver entry.
A message indicates that Setup has recognized the MEGARAID adapter.
d. Enter S to specify an additional SCSI adapter.
The adapter selection window reappears.
e. Press Enter to select the highlighted Other entry. You are prompted to insert a
diskette containing the controller drivers diskette.
Windows NT Server Setup
=======================
Please insert the disk labeled
Manufacturer - supplied hardware support disk
into Drive A:
*Press ENTER when ready
f. Insert the Unisys diskette labeled “DRIVER-SDMS PCI SCSI NT 896 Driver”
(23381676–000) and press Enter.
g. After a brief wait, the Symbios driver is listed in the adapter window.
h. Press Enter to select the highlighted Symbios PCI High Performance Driver entry.
A message indicates that Setup has recognized the Symbios adapter.
7850 5104–009 Version 009B (Web Only) 5–15