ClearPath IX Systems Installation and Configuration Guide

Installing Windows NT Server, Enterprise Edition (ES2045R)
A Management Menu for configuring RAID logical arrays appears as follows:
----Management Menu----
Configure
Initialize
Objects
Format
Rebuild
Check Consistency
Disable BIOS
3. Select the Configure option using the arrow keys, then press Enter.
A Configure menu appears:
------Configure-----
Easy Configuration
New Configuration
View/Add Configuration
Clear Configuration
Note: Unless noted otherwise, use the arrow keys to select menu options
throughout the rest of this procedure.
4. Select Clear Configuration, then press Enter.
The following prompt usually appears:
Clear Configuration?
YES
NO
5. If the prompt in step 4 appears, highlight YES, then press Enter.
Note: You may instead receive a message “no existing configuration to clear.” If
so, proceed to step 6.
6. Press any key to continue.
7. Select the Easy Configuration option, then press Enter.
After a brief wait, an Easy Configuration–ARRAY SELECTION MENU appears
showing the available disk drive units (Figure 5–1 shows two units available).
Note: The CD-ROM position in Channel-3 may be at 6 instead of 4.
5–10 Version 009B (Web Only) 7850 5104–009