ClearPath IX Systems Installation and Configuration Guide

Installing Windows NT Server, Enterprise Edition (ES2045R)
That message indicates that the RAID configuration saved in nonvolatile memory by
the RAID controller does not match the current configuration. Take the following
steps to correct the problem. (If the message does not appear, proceed to step 2.)
a. As indicated by the message, press any key to enter the configuration utility.
The Management Menu for configuring RAID appears as follows:
----Management Menu----
Configure
Initialize
Objects
Format
Rebuild
Check Consistency
Disable BIOS
b. Select Configure, then press Enter.
A Configure Menu appears as follows:
------Configure-----
Easy Configuration
New Configuration
View/Add Configuration
Clear Configuration
c. Select View/Add Configuration, then press Enter.
A popup menu appears.
d. Select View Disk Configuration, the press Enter.
A screen similar to Figure 5–1 appears, except the disks say ONLIN A1-1 and
ONLIN A1-2 instead of READY.
e. Press F10.
A Save Configuration? menu appears.
f. Select YES, then press Enter.
You are returned to the previous menu.
g. Press any key to continue.
h. Press Esc three times to back out of all menus.
The following prompt appears:
------EXIT?-----
YES
NO
i. Select YES, then press Enter.
j. Press Ctrl-Alt-Del to reboot.
A Software License Agreement screen appears.
5–4 Version 009B (Web Only) 7850 5104–009