ClearPath IX Systems Installation and Configuration Guide

Installing Windows NT Server, Enterprise Edition (ES5044R, ES5085R, and
ES2024R)
b. Security tab—Click this tab, then clear the check box labeled Send Authentication
Trap. Leave the Accept SNMP Packets from Any Host option set.
c. Click OK.
d. If you select IPX/SPX protocol (see step 16), you are prompted to assign a unique
network number to one of the adapters.
After about a minute, a tabbed Microsoft TCP/IP Properties screen appears.
27. Configure the FDDI network adapter card as follows:
a. Use the scroll bar to select the following adapter from the drop-down list of
adapters:
SK-NET FDDI PCI Adapter
b. Click the IP Address tab, then enter IP address information as follows:
1) Click “Specify an IP address” to select it.
Note: You must know if this Windows 2000 or NT server node is being
installed as the first, second, third, or fourth Windows node in the
ClearPath IX system to which it is connected. You will use the IP
address associated with that node number. The addresses are listed
in Table B-1.
2) In the IP Address field, type the appropriate FDDI address for this node (for
example, 192.168.057.003 for the first Intel node) as described in Appendix B,
Table B–1. Then press Tab.
3) In the Subnet Mask field, enter the address 255.255.255.0.
c. Click Advanced.
1) Click the Add button in the IP Addresses box.
2) Enter the other two addresses and subnet masks for Windows NT from Table
B–1.
3) Click OK.
28. Configure the Ethernet network adapter card as follows:
a. Click the IP Address tab.
b. Use the scroll bar to select one of the following:
• For the ES5044R, the Intel EtherExpress Pro
• For the ES5085R, the Intel EtherExpress PRO adapter Bus 3 slot 4 from the
drop-down list of adapters
• For the ES2024R, the AMD PCNET PCI Ethernet Adapter
c. Enter the following IP address information:
1) Click “Specify an IP address.”
2) In the IP Address field, enter the IP address for the Windows NT node from
Table 2–2, then press Tab.
3) Change the subnet mask to the netmask address from Table 2–2, or skip this
field (accept the default).
7850 5104–009 Version 009B (Web Only) 4–23