ClearPath IX Systems Installation and Configuration Guide

Installing Windows NT Server, Enterprise Edition (ES5044R, ES5085R, and
ES2024R)
18. Add the additional services to the list as follows:
a. Click “Select from list . . .”
b. Scroll down the list of services (use the scroll bar) and highlight Simple TCP/IP
Service.
c. Click OK.
The service is added to the list of services already in the list box.
d. Repeat steps a, b, and c for SNMP Service.
e. Review the list of services to ensure that it contains the following:
• Microsoft Internet Information Server 2.0
• Remote procedure call (RPC) configuration
• Network Basic Input/Output System (NETBIOS) Interface
• Workstation
• Server
• Simple TCP/IP service
• SNMP service
f. Click Next to proceed.
A Windows NT Server Setup screen indicates that Windows NT is now ready to install
networking components.
19. Click Next.
20. For the ES5085R only, a screen for setting FDDI parameters appears.
Click Continue to accept the defaults.
21. Depending on the server model you are installing, either Intel PRO or AMD PCNET PCI
adapter information is displayed. Click Continue.
Note: For the ES5085R, two adapters should be detected.
22. If you are installing an ES2024R or ES5044R, a screen for setting FDDI parameters
appears.
Click Continue.
23. If you are installing an ES5085R, click OK.
24. For both server types, installation of networking components begins. A message box
asks if you want to use Dynamic Host Configuration Protocol (DHCP) server.
25. Click No.
Messages indicate software is being installed. After about 1 minute, you are prompted
with a tabbed SNMP Properties screen.
26. Set the SNMP properties as follows:
a. Agent tab—Click this tab, then enter the name and location of the system
administrator. Accept the service defaults (Applications, Internet, and End-to-
End).
4–22 Version 009B (Web Only) 7850 5104–009