ClearPath IX Systems Installation and Configuration Guide

Installing Windows NT Server, Enterprise Edition (ES5044R, ES5085R, and
ES2024R)
into Drive A:
*Press ENTER when ready
8. Insert the diskette labeled “1- X CPU Edition Setup Disk 3” in the drive, then press
Enter to continue.
A message indicates that setup has recognized all of your adapters.
9. Press Enter to continue.
The following message appears at the top of the screen, followed by a message
confirming that the adapters have been recognized.
Windows NT Server Setup
=======================
Setup has detected that one or more of your hard disks has more than 1024
cylinders
10. Press Enter again.
A message states that Setup has detected that your computer’s hard disk is new.
11. Press C to continue.
You are prompted to insert the CD-ROM.
12. Insert the CD-ROM and wait for the drive light to stop flashing; then press Enter.
A license agreement text screen then appears.
13. Read the contents of the license agreement as follows:
a. Read the contents of the first page, then press the Page Down key to read the next
page.
b. When you reach the last page, press F8 to indicate that you agree with the terms of
the license agreement .
A hardware and software components list appears for you to verify.
14. Be sure that the Computer line reads “MPS Multiprocessor PC.” If it does not, use the
arrow keys to move to that line, press Enter, and change as needed.
15. Press Enter to continue.
A screen appears that identifies the unpartitioned disk space.
4–16 Version 009B (Web Only) 7850 5104–009