ClearPath IX Systems Installation and Configuration Guide

Installing Windows NT Server, Enterprise Edition (ES5044R, ES5085R, and
ES2024R)
Manufacturer - supplied hardware support disk
into Drive A:
*Press ENTER when ready
b. Insert the diskette containing the RAID drivers labeled “Mylex Solutions Software
Kit x.xx NX/NW Drivers Diskette” and press Enter to continue.
After a brief wait, the Mylex…Disk Array Controller drivers are listed in the
adapter window.
c. If you have the DAC1100 RAID Controller, select the highlighted “Mylex
DAC960…Disk Array Controller” entry. If you have the AcceleRAID 352 RAID
Controller, select “Mylex EXR2000/3000…Disk Array Controller. Then press
Enter.
A message indicates that Setup has recognized the Mylex adapter.
d. If you are installing the ES2024R or ES5044R, skip to step j.
e. Enter S to specify an additional SCSI adapter.
The adapter selection window reappears.
f. Press Enter to select the highlighted Other entry. You are prompted to insert a
diskette containing the controller drivers diskette.
Windows NT Server Setup
=======================
Please insert the disk labeled
Manufacturer - supplied hardware support disk
into Drive A:
*Press ENTER when ready
g. Insert the Unisys diskette labeled “Unisys Supplemental Drivers” (23389166- xxx)
and press Enter.
h. After a brief wait, the Symbios driver is listed in the adapter window.
i. Press Enter to select the highlighted “Symbios PCI High Performance Driver”
entry.
A message indicates that Setup has recognized the Symbios adapter.
j. Enter S to specify an additional SCSI adapter.
The adapter selection window reappears.
k. Use the up and down arrow keys to select IDE CD-ROM (ATAPI 1.2)/PCI IDE
Controller.
l. Press Enter to select the highlighted entry (IDE CD-ROM…).
You are prompted to insert disk 3, as follows:
Windows NT Server Setup
=======================
Please insert the disk labeled
Windows NT Server Setup Disk #3
7850 5104–009 Version 009B (Web Only) 4–15