solidworks

Structure System and Weldments
3. In the graphics area, select the point on the plane labeled Up to point.
Point1@Uptopoint displays in the PropertyManager.
4. In the Member tab, click in the Points And Length box .
5. In the graphics area, select points 8, 5, and 7 as shown.
6. Click .
Creating Primary Members Based on Direction
To create primary members based on direction:
1. In the Member tab, under End Condition, select Length.
2. Under End Condition, click in the Direction of Member box .
3. In the graphics area, select the sketch line that appears in a magenta color.
When you select the sketch line, the color changes to orange.
The PropertyManager displays Line1@For direction control.
4. In the graphics area, click the remaining corner on the rectangle on the Top plane.
5. In the Member tab, enter 280.00mm for Length.
6. Unpin the PropertyManager and click .
7. Click Structure System in the Confirmation Corner to exit Structure System
mode.
8. In the Corner Management PropertyManager, click .
204