solidworks

Structure System and Weldments
Creating Primary Members Between Points
To create primary members between points:
1. In the Member tab, under End Condition, select Point.
2. Under Points And Length, click Chain Link .
The end point of one member is used as the beginning of the next pair in the chain.
3. In the graphics area, click each point at the corners of the rectangle on the Top plane.
The PropertyManager lists the following pairs:
• Point8@Base Point, Point6@Base Point
• Point6@Base Point, Point7@Base Point
• Point7@Base Point, Point5@Base Point
• Point5@Base Point, Point8@Base Point
4. Click .
Creating Primary Members Based on Up to Point
To create primary members based on up to point:
1. In the Member tab, under End Condition, select Up to Point.
2. Under End Condition, click in the End Condition box .
203