solidworks

Model Display
3. Compare the edges of the gear teeth for Gear1 and Gear2.
a) After viewing the filleted edges of Gear1, right-click Gear1 and click Hide .
b) Right-click Gear2 and click Show to view the nonfilleted edges.
Gear1: Filleted Edges
Gear2: Nonfilleted Edges
4. Click View > Display > Body Compare .
5. In the PropertyManager, set the following options:
a) For Source Bodies, select Gear1
b) For Compare Bodies, select Gear2
c) Move the Legend Threshold slider so the top and bottom numbers in the legend
are approximately 1.00mm.
In the graphics area, the red and yellow colors indicate where Gear1 and Gear2 do
not match.
6. Click .
7. To clear the Compare Body Legend, in the graphics area, right-click the legend and
click Body Compare .
To open the Body Compare PropertyManager, right-click the legend and click Body
Compare Properties.
122