ATH-Heinl Bedienungsanleitung Single Lift 25M

5. Press and hold the lowering button for approx. 3 seconds after the lift has reached its lowest point to allow
any trapped air to escape.
6. Repeat this lifting and lowering process three times.
Attention
Do NOT operate the unit without oil.
Otherwise the pump may be damaged. If the motor gets hot or makes strange noises, stop
immediately and check the electrical connection again.
Advice
Make sure to top up the oil if there is not enough oil in the circuit during the bleeding
process.
1 2
1. If necessary, press the lower button and at the same time push the piston rod as far as possible into the
cylinder by pressing on the chain roller or pulling on the chain.
2.
Slightly open the screw plug
of the unit on the cylinder slightly.
3.
Attach a hose (not included in the scope of delivery) to the connection
hydraulic pump via the tank cap.
and feed it into the tank of the
4. Press the “Lift” button for approx. 1 minute.
® Copyright1 / Copyright2 / Copyright3
Stand: 10.07.2024 / Copyright4
77