Appendix E-2.c.i Energy Plan 2004-2013 Follow-up Studies and ...

More documents

Recommendations

Info

Re-powering Study for the Northport and Port Jefferson Power Stations Appendix II Northport System Descriptions Low point drains are in accordance with ASME TPD, “Recommended Practices for the Prevention of Water Damage to Steam Turbines Used for Electric Power Generation”. 1.4 Low Pressure Steam Refer to PID-03-04A and PID-03-4B in Appendix III. The LP steam system directs superheated steam from the LP superheater outlet of each HRSG to the steam turbine low pressure admission valves. The LP steam line from each HRSG contains a flow orifice, a bypass branch, and a motor operated stopcheck valve. For Northport Hybrid Option, the HRSG lines combine into a common header en route to the steam turbine. The common header connects to a single connection in the intermediate pressure (IP) steam turbine outlet. Admission stop and control valves are installed in the LP steam piping near the steam turbine. The LP steam combines with the IP turbine exhaust steam and travels through the crossover into the LP section of the steam turbine. The LP steam bypass valves provide a means for bypassing LP steam to the condenser during startup and during steam turbine trip conditions. The LP steam lead from each HRSG is equipped with a steam conditioning valve (bypass valve) to lower the steam pressure and temperature to acceptable condenser design levels. Attemperating water for the steam conditioning valves is from the condensate system through temperature control valves. Low point drains are in accordance with ASME TPD, “Recommended Practices for the Prevention of Water Damage to Steam Turbines Used for Electric Power Generation”. 1.5 Auxiliary Steam Refer to PID-03-05A in Appendix III. 1.5.1 General The auxiliary steam system provides 150 psig steam at 520ºF to the condenser steam jet holding air ejector, and the steam turbine gland steam system. The source of the steam for the auxiliary steam system is from the cold reheat system. During start up steam is provided to the auxiliary steam system from the main steam system. Both sources of steam are each provided with pressure reducing valves to lower steam pressure to the correct auxiliary steam pressure. Two desuperheater stations are provided to condition the auxiliary steam from either source. The Auxiliary Steam System also provides cooling steam to the M501G during startup and shutdown as per MHI requirements. This steam is generated by the Auxiliary boiler in accordance with MHI quality, flow, pressure, and temperature requirements. During short duration outages, typically overnight and weekends, or whenever it is desired to maintain the plant in a hot or warm condition and during normal plant start-ups, steam is supplied by the auxiliary boiler. The system is equipped with roof mounted safety valves, system traps and drains, as well as suitable nonreturn valves and isolation valves to prevent steam back flow during unit trips. The source of the desuperheater water is from the condensate pump discharge. The Auxiliary steam system contains the following major components: March 30, 2009 148
Re-powering Study for the Northport and Port Jefferson Power Stations Appendix II Northport System Descriptions • Main Steam Letdown Pressure Control Valve • Cold Reheat Letdown Pressure Control Valve • Main Steam Letdown Attemperating Water Spray Control Valve • Cold Reheat Letdown Attemperating Water Spray Control Valve • Auxiliary Boiler System • All associated piping and instrumentation. 1.5.2 Auxiliary Boiler System The auxiliary boiler for The Hybrid Option is a natural gas fired watertube packaged boiler with an integral superheater. The auxiliary boiler is equipped with single or double low-NOX burners, a forced draft fan and a stack. The following ratings apply to the auxiliary boiler: • Boiler Capacity – To be determined • Design Pressure – 400 psig • Operating Pressure – 300 psig • SH Steam Temperature – 520 °F • Feedwater Temperature - 228 °F The auxiliary boiler system is supplied with support equipment including a deaerator, feedwater pumps, blowdown tank, chemical feed equipment, instrumentation and associated control system for independent operation. 1.5.3 Auxiliary Steam Attemperating Valves The main steam and the cold reheat auxiliary steam attemperating valve conditions superheated main steam to maintain a nominal pressure of 150 psig at a temperature of approximately 520 oF. The condensate system provides attemperating water spray via a temperature control valve to maintain the required steam conditions at setpoint. 1.5.4 Air Ejectors The existing Unit 4 air removal system will remain in service 1.5.5 Steam Turbine Gland Sealing Steam The existing Unit 4 steam turbine gland sealing system will remain in service. 1.6 Condensate Refer to PID-04-01A and 04-01B in Appendix III. The Condensate Systems for the Northport Hybrid Option each have two 100 percent condensate pumps. The second condensate pump is started for steam turbine bypass operation. The new condensate pumps will replace the existing pumps in the same location. The 100 percent capacity vertical turbine-type centrifugal condensate pumps, set in suction cans, take suction from the condenser hotwell through individual suction lines and hotwell connections. The Condensate System supplies condensate to both electric and steam air ejectors, gland steam condenser, LP economizers of each HRSG, auxiliary steam desuperheater, hot reheat and LP steam bypass valves, March 30, 2009 149
Page 1 and 2: Electric Resource Plan 2010 - 2020
Page 3 and 4: March 30, 2009 Re-powering Study fo
Page 5 and 6: Northport Repower Study Option 4 2x
Page 7 and 8: Re-powering Study for the Northport
Page 9: Re-powering Study for the Northport
Page 21 and 22: • Auxiliary Boiler System • All
Page 31 and 32: 1 2 3 4 5 6 7 8 9 10 A SUPERHEATER
Page 33 and 34: 1 2 3 4 5 6 7 8 9 10 A 0304 PID-03-
Page 35 and 36: 1 2 3 4 5 6 7 8 9 10 A 0341 PID-03-
Page 37: 1 2 3 4 5 6 7 8 9 10 A 0368 PID-03-
Page 40 and 41: 1 2 3 4 5 6 7 8 9 10 A 0831 PID-08-
Page 42 and 43: 1 2 3 4 5 6 7 8 9 10 A 0427 PID-04-
Page 44 and 45: 1 2 3 4 5 6 7 8 9 10 A FGS FGS FGS
Page 46 and 47: 1 2 3 4 5 6 7 8 9 10 A 0823 PID-08-
Page 50 and 51: 1 2 3 4 5 6 7 8 9 10 0904 PID-09-09
Page 52 and 53: 1 2 3 4 5 6 7 8 9 10 A FROM AIR COM
Page 54 and 55: 1 2 3 4 5 6 7 8 9 10 A REVISION DES
Page 56 and 57: 1 2 3 4 5 6 7 8 9 10 A 1330 PID-13-
Page 58 and 59: 1 2 3 4 5 6 7 8 9 10 A FROM HRSG 1A
Page 60 and 61:
1 2 3 4 5 6 7 8 9 10 A 0304 PID-03-
Page 62 and 63:
1 2 3 4 5 6 7 8 9 10 A 0341 PID-03-
Page 64 and 65:
1 2 3 4 5 6 7 8 9 10 A 0368 PID-03-
Page 66 and 67:
1 2 3 4 5 6 7 8 9 10 A REVISION DES
Page 68 and 69:
1 2 3 4 5 6 7 8 9 10 A 0831 PID-08-
Page 70 and 71:
1 2 3 4 5 6 7 8 9 10 A 0427 PID-04-
Page 72 and 73:
1 2 3 4 5 6 7 8 9 10 A FGS FGS FGS
Page 74 and 75:
1 2 3 4 5 6 7 8 9 10 A 0823 PID-08-
Page 76 and 77:
1 2 3 4 5 6 7 8 9 10 CCW VSH 0132A
Page 78 and 79:
1 2 3 4 5 6 7 8 9 10 0904 PID-09-09
Page 80 and 81:
1 2 3 4 5 6 7 8 9 10 A FROM AIR COM
Page 82 and 83:
1 2 3 4 5 6 7 8 9 10 A REVISION DES
Page 84 and 85:
1 2 3 4 5 6 7 8 9 10 A 1330 PID-13-
Page 86 and 87:
Re-powering Study for the Northport
Page 88 and 89:
Fuel Systems Re-powering Study for
Page 90 and 91:
Accessory Electric Plant Re-powerin
Page 92 and 93:
Fuel and Feed Re-powering Study for
Page 94 and 95:
Accessory Electric Plant Re-powerin
Page 96 and 97:
Page 98 and 99:
Page 100 and 101:
Page 102 and 103:
Page 104 and 105:
Page 106 and 107:
Page 108 and 109:
Page 110 and 111:
• Grounding and lightning protect
Page 112 and 113:
Page 114 and 115:
• Combustion turbine foundation
Page 116 and 117:
D3 Fuel Oil facilities Re-powering
Page 118 and 119:
show all

Appendix E-2.c.i Energy Plan 2004-2013 Follow-up Studies and ...

Create successful ePaper yourself

Delete template?

Save as template?