Cleco-2019-full-catalog-v3-links

Air Motors
21 Series - Air Motor - Rotary Vane - Rear
Exhaust
Maximum Power 0.3 hp | 0.22 kw
• Maximum Power 0.3 hp | 0.22 kw
• Torque Range 0.2 - 15.2 ft. lbs. | 0.27 - 20.6 Nm
• Non-Reversible
• Rear Exhaust
MODEL MOUNT SPINDLE TYPE
21M1041-49
21M1340-49
FLANGE AND BASE
MOUNTING
FLANGE AND BASE
MOUNTING
21-1041-49 ROUND
21-1340-49 ROUND
21-1940-49 ROUND
21M1540-49
FLANGE AND BASE
MOUNTING
3/8 IN KEYED
SPINDLE
3/8 IN KEYED
SPINDLE
3/8 IN KEYED
SPINDLE
3/8 IN KEYED
SPINDLE
3/8 IN KEYED
SPINDLE
3/8 IN KEYED
SPINDLE
RPM AT FREE TORQUE
AIR CON-
WEIGHT
LENGTH HORSEPOWER
MAX HP SPEED STALL
GEAR
SUMPTION
RATIO
R/MIN R/MIN FT LB | NM LB KG IN | MM HP SCFM
CONTROL
300 600 9.9 | 13.41 2.1 0.95 44.82-1 5.66 | 144 0.3 12 NON-REVERSIBLE
1600 3200 1.8 | 2.44 2.1 0.95 8.3-1 4.34 | 110 0.3 12 NON-REVERSIBLE
300 600 9.9 | 13.41 2.1 0.95 44.82-1 5.66 | 144 0.3 12 NON-REVERSIBLE
1600 3200 1.8 | 2.44 2.1 0.95 8.3-1 4.34 | 110 0.3 12 NON-REVERSIBLE
15000 30000 0.2 | 0.27 2.1 0.95 1-1 3 | 76.2 0.3 12 NON-REVERSIBLE
2500 5000 1.2 | 1.63 2.1 0.95 5.4-1 4.34 | 110 0.3 12 NON-REVERSIBLE
Air Inlet: 1/4” NPT – Side and rear
All tools performance rated @ 90psi (620 kPa) air pressure.
*Optional Terminations:
Replace -49 in model number with the desired termination when ordering.
-38 0”-1/4” Capacity Drill Chuck (5000 RPM or less)
-51 1/16”-3/8” Capacity Drill Chuck (5000 RPM or less)
-40 3/8”-24 Threaded Spindle
-01 Series 200 Collet Chuck (for milling and routing)
-36 Series 300 Collet Chuck (for milling and routing)
Standard Equipment:
Hex socket screw provided for closure of unused inlet. Flush fitting for lubrication of gears. Wrench for threaded spindle and collet chuck models. 1/4” collet included with series 200 & 300 collet
chuck.
Optional Equipment:
Any series 200 collet may be substituted at no additional cost. On series 300 collet chuck, collets 301, 302, and 303 are available at extra cost.
**Please visit clecotools.com for dimensional diagrams and power curves.
Air Motors
130 CLECOTOOLS.COM