Nordson's Adhesives & Sealants Guide - 2020-2021 (13th Edition)

16-4 | Accessories
In-Line Filters
Heated In-line Filters
Inserted between the hose and applicator, the
heated in-line filter provides final adhesive filtering
immediately before applicator deposition. It helps
balance temperature swings in extreme environments
and removes char or contaminants that can cause
nozzle clogging. The filter consists of a large surfacearea
filter screen assembly contained in a heated
aluminum body.
• Use with high-viscosity hot melts over 10,000
centipoise.
• Cartridge heater and button thermostat provide
independent heat and temperature control. Nordson
does not recommend combining the thermostaticallycontrolled
filter with RTD-style hoses and applicators.
• Choice of thermostat settings ranges from 50° to
230° °C (120 to 450 °F) to maintain operating
temperature consistency throughout the system. Specify
required thermostat when ordering; otherwise, a
175 °C (350 °F) thermostat is standard.
Specifications
Item
Electrical service
Specification
240 VAC 50/60 Hz
120 VAC, 50/60 Hz (includes 145 W heater)
• Selection of filter screen mesh sizes matches application
requirements to maximize filtration. Each filter includes
a 0.15 mm (0.006 in.) screen. Order different mesh
sizes separately.
• Filter screen is readily accessible for removal and
cleaning. Drain valve flushes loose contamination out
of the body during filter-screen removal.
• Filter is wired in parallel with the applicator and
includes two armored cordsets; one attaches the filter
to the hose, while the other replaces the standard
applicator cordset and attaches the applicator to the
filter.
Question from Jeff:
Inline filters, page 16-4, in the PN table:
803124 is not in SAP.
803231 is in SAP but is coded as not saleable.
There is this good saleable one that is not listed
there: 1501984 FILTER, IN-LINE, HTD, 2300 CRDST
Part Numbers
P/N Description Comment
309100 Filter, 240 VAC
803124 Filter, 120 VAC Includes heater, 145 W, 120 VAC, P/N 803123
803231 Filter, drum melters, 240 VAC
Attaches to 5/16 in. hose fitting at manifold and uses
5/8 in. hose fitting on the output side
249954 Filter screen, 0.05 mm (0.002 in.)
161133 Filter screen, 0.10 mm (0.004 in.)
161130 Filter screen, 0.15 mm (0.006 in.) Shipped with filter
161134 Filter screen, 0.23 mm (0.009 in.)
To place your order, NAD call 1-888-NORDSON (1-888-667-3766), fax 1-770-497-3733 or online at www.enordson.com.
International Orders, call 1-440-985-4797, fax 1-440-985-1096, or email intcustomerservice@nordson.com